Forecast troubleshooting

Why doesn't my solar forecast match my generation?

Your forecast is a weather-based estimate, not a reading from your inverter. A few setup details can make a substantial difference—and Solar Forecast UK deliberately starts with a cautious assumption about system losses.

First, understand our cautious starting point

When you add an installation, the Recommended setting uses an 18% system-loss allowance. The calculation also separately assumes 96% inverter conversion efficiency. These assumptions aim to avoid treating an ideal, loss-free solar array as a typical real-world system.

That means a well-performing installation may regularly generate more than the initial forecast. It is also possible to generate less: an unexpected cloud bank, shading or other local conditions can outweigh the cautious defaults. This is not a guaranteed minimum forecast or a prediction interval.

If you know your installation well, you can review Advanced settings → System efficiency. Options include a lower-loss setting, a more conservative setting and custom losses. For a saved installation, entering complete daily generation readings can help the forecast adjust over time through bounded learning.

1. Check the direction your panels face

Choose the direction the panels face, not the direction your house faces. The app uses South = 0°, East = −90° and West = +90°. East-facing panels typically produce more in the morning; west-facing panels tend to be stronger later in the afternoon.

If you have panels on different roof faces—such as east and west—add them as separate arrays, each with its own rated capacity, direction and tilt. Entering the whole installation as one south-facing array can make the shape of the hourly forecast misleading.

2. Check the panel tilt

Tilt is the angle of the panel from horizontal: 0° is flat and 90° is vertical. It is not the angle measured from an upright wall. An incorrect tilt can change predicted output, especially when the sun is low in winter.

If your panels are mounted flush with a pitched roof, your installer's paperwork may show the roof pitch. Otherwise, use a reasonable estimate and avoid adjusting it just to match one day's generation.

3. Check capacity, losses and the inverter limit

Enter panel capacity in kWp (the panels' rated peak capacity), not the inverter's kW rating or a daily kWh figure. Check each array separately if they have different capacities or orientations.

The system-loss setting represents real-world effects such as wiring, mismatch, dirt, temperature and shading. The inverter conversion allowance is modelled separately. If you know the maximum AC output of your inverter, you may also set an inverter limit; an incorrect limit can make midday peaks appear too low.

Don't remove all losses simply to make the forecast larger. A consistent difference over several complete days is more informative than a single sunny afternoon.

4. Compare the same quantity and the same period

A chart showing kW is hourly power, while the daily total in kWh is energy. For a fair comparison, use your inverter's total solar generation over the same complete day. Grid-export figures alone are usually lower because they exclude electricity used in your home.

Compare matching UK-local dates and be aware that a forecast can change as newer weather information becomes available. A forecast you saw yesterday may differ from the revised estimate shown today.

5. Allow for weather and your particular roof

Cloud timing can differ substantially over short distances. Trees, chimneys, neighbouring buildings, snow, dirt, panel temperature, equipment faults and inverter clipping can all affect real output in ways a weather model cannot fully observe. A roof with morning shade might consistently underperform its unshaded estimate at that time.

Forecasts further into the week are generally less certain than near-term forecasts. The confidence label on Solar Forecast UK describes forecast lead time, not a statistical guarantee of accuracy.

What should I do if my forecasts are consistently low or high?

First check direction, tilt, kWp capacity and any inverter limit. Then compare several complete days, including different weather conditions, before reconsidering the system-loss setting. If you have a saved installation, record actual daily generation so its learning can adjust persistent differences within safeguards.

A cautious starting assumption is intentional; it does not mean every individual forecast should be pessimistic. The goal is a useful planning estimate that becomes better matched to your installation as you provide reliable readings.

Check your installation settings